UNO help please. avrdude: stk500_recv(): programmer is not responding. Avrdude, stk500, Bootloader issues. 10: 45143: May 6, 2021. avrdude: ser_recv(): programmer is not responding. avrdude: stk500_recv(): programmer is not responding. avrdude: stk500_getsync() attempt 1 of 10: not in sync: resp=0x00. What I tried: I have 4 Uno's at the table (original + free versions), the same issue. I have installed newest drivers from here, tried with and without them.
Arduino の avrdude stk500_recv() programmer is not responding エラー KOKENSHAの技術ブログ
Solución de Error avrdude stk500 recv programmer is not responding Arduino YouTube
avrdude stk500_recv() programmer is not responding + avrdude stk500_getsync() attempt 10 of
arduino nano 报错：avrdude stk500_recv() programmer is not responding（已解决）CSDN博客
Flash error avrdude stk500_recv() programmer is not responding avrdude stk500_getsync
avrdude stk500_recv() programmer is not responding SOLVED
Arduino nano板 上传项目出现avrdude stk500_getsync() attempt 1 of 10 not in sync resp=0x00问题更改为Old
Arduino Sketch upload issue avrdude stk500_recv() programmer is not responding » DIY Usthad
EEPROM with ARDUINO UNO, avrdude stk500_recv() programmer is not responding Avrdude, stk500
Troubleshooting Arduino Sketch Upload Issue avrdude stk500_recv Programmer is Not Responding
How to Fix Avrdude Stk500 Recv Programmer Is Not Responding Error
Getting `stk500_recv() programmer not responding` on arduino Pro mini 5V · Issue 1
avrdude stk500_recv() programmer is not responding Avrdude, stk500, Bootloader issues
Troubleshooting Guide Avrdude Stk500_Recv Programmer Not Responding
UNO R3 + WIFI CH340G avrdude stk500_recv() programmer is not responding Avrdude, stk500
avrdude stk500_recv() программатор не отвечает, arduino pro (serial, arduino pro mini
Avrdude stk500_recv() programmer is not responding Actualizado marzo 2024
avrdude stk500_recv() programmer is not responding arduino
Android Arduino avrdude stk500_recv() programmer is not responding
Avrdude stk500_recv() Programmer Not Responding Custom Arduino Uno Avrdude, stk500
Open the device and disconnect (remove) connection board for approx. 30 seconds from the control board - RTC is disconnected from power (gold cap disconnected) and because of that there is reset of all RTC registers. Plug the connection board back in to the control board.. Hi @fabulito.Please add a reply here on this forum thread to tell us which Arduino board you are using. Please be as specific as possible as some Arduino boards with similar names have significant differences and the forum helpers can only provide effective assistance if we are aware of which one is being used.
